Air Cooler freezing and air venting methods

Table Air Cooling Fan is usually caused by a long-term power off and the design of the computer motherboard is not maintained against cold, the external temperature is too low if it is summer, there is no water flow switch installed or the water flow switch is short-circuited, at the same time the temperature sensor temperature measurement is also prohibited. Next, let's take a look at how to deal with a freezing Air Cooler and how to vent the air. Here are some answers.

Here is the content list:

• What should I do if my Air Cooler freezes over?

• Air Cooler's exhaust method.

What should I do if my Air Cooler freezes over?

First of all, the generator set is constantly distributed, and the system software of the air heat pump heating is made of water as the medium of transmission. Normal words Air Cooler equipment is equipped with an anti-freezing effect, in the water temperature is low to a certain temperature, Commercial Air Cooler equipment is fully automatic open, to prevent machinery and equipment and pipeline freezing. Secondly, the insulation of the pipes is strengthened and the exposed water pipes are given a protective cover. Also known as rock wool board raw materials made. In the insulation pipeline before the actual operation to check the pipeline and the wall and other pipelines, machinery, and equipment between the spacing, found insufficient insulation parts, and need to rectify. Pipe sleeve and pipe sleeve in the middle of the joint, the end surface of the pipe sleeve coated with insulation glue, pipe sleeve longitudinal seam provisions separate, and the longitudinal seam is generally not vertical down, pipe sleeve and pipe sleeve in the middle with a strong adhesive will be seam sealing. In addition, finned heat exchangers' condensation should be properly disposed of. Can pull up the server installation part, usually under the circumstance stipulates the server from the road high should not be less than 30cm, for the wind and snow is a more serious geographical area, pull up to in 50 centimeters above; In the server, car chassis elevate the electric accompaniment heat, melts up the frost ice; In the condensation water or defrost water diversion bag road surface package capsule electric accompaniment heat, prevent the freezing. In addition, also a need for the fin heat exchanger into the drainage open tee, install drainage; in the system software solution plus ethanol alcohol; in the system, software add car antifreeze; heat pump unit around the dirty and snowfall immediately remove these, that way drain away many unfavorable conditions.

Air Cooler's exhaust method.

There are two methods of natural ventilation for the Air Cooler: the fan type is where the gas flows through the exhaust fan before being injected into the pipe. The induced draft type is where the gas flows through the ductwork first and is then injected into the exhaust fan. The former kind of actual operating cost is more economic development, caused by the middle of the joint to heat conduction is good, the application is more. The latter kind of cyclone all over the uniform, convenient temperature control, noise is small, is the development trend of the orientation. The temperature of the thermal liquid entrance and exit key relies on the adjustment according to the tube to teach the amount of exhaust air to manipulate, that is, adjust the inclination of the leaf surface, exhaust fan speed ratio, and the opening level of the blinds, etc. For liquids that are prone to condensation and freezing in winter, warm air or steam heat exchangers can be used to adjust the liquid inlet and outlet temperatures.

If you are interested in our Air Cooler products or have other requirements, please feel free to contact us. Our official website is https://www.helenbo.com/. Dedicated to bringing more and better products to our customers, this is what we are always doing.